Blue Edge Financial

How to Set Up Heron Copier on C-Trader


 

 

Introduction


This guide explains installing and connecting Heron Copier to your C-Trader terminal.

Installation Steps

1. Open C-Trader Terminal

    • Launch your C-Trader terminal.

2. Download Heron Copier Files

  • Access the Heron Copier download you received.

3. Install Master and Slave

  • Install Master:
    1. Double-click the Master file.
    2. If prompted, choose to override the existing installation.
    3. Wait for the installation to complete, then close the installer.
  • Install Slave:
    1. Repeat the steps for the Slave file.
    2. Click yes to confirm, and close the installer once complete.

4. Verify Installation

  • Go to the Trade tab in C-Trader.
  • You should see Heron Copier Master and Heron Copier Slave listed.

Connecting Master and Slave

1. Add HeronCopier Master to Your MT5 Terminal

  • Open your MT5 terminal.
  • Drag the Master file onto the terminal.
  • Configure the inputs as required for your setup.
  • Enable Algo Trading and click OK.

2. Set Up Heron Copier Slave

  • Drag the Slave file onto the terminal.
  • No additional configuration is required for the Slave file.
  • Click Apply to complete the setup.

Testing the Connection

  • Ensure both Master and Slave are connected.
  • When trades occur on the Master, they will automatically copy to the Slave.

Conclusion


Installing and configuring Heron Copier on your C-Trader terminal is a straightforward process. Once set up, the system will seamlessly copy trades between your accounts. For further assistance, contact support.


Was this answer helpful?

« Back